Intellinet-network NSC18-WN User Manual Instrukcja Użytkownika Pobierz pdf (Strona 16)

WEB MANAGEMENT INTERFACE

OntheSecurityscreen(above),youcanchangethecamera’sname

andpassword(asontheLoginscreen,theusernameisalways“admin”

andcan’tbechanged).Besureyouenterthesamepasswordinboth

the“NewPassword”and“ConrmPassword”elds;otherwise,you’ll

be prompted to enter the new password again. Click “OK” to save the

settings;click“Cancel”todiscardchanges.

3 Web maNagemeNT iNTerfaCe

3.1 Logging On

With new camera purchases, there should be no problem with the login/

logon procedures. Remember, however, that if you have obtained this

camera from another party after initial installation, then you’ll probably

need to reset the password.

1. With the camera powered on, launch your Web browser and enter

the IP address of the camera in the address bar.

2. When the Internet Camera login

 screendisplays(right),entera

username and password and

click “OK.” As before, the “User

Name” and “Password” defaults

are “admin” and “1234.” NOTE:

If this login screen doesn’t

display, go back and re-enter

the IP address as necessary.

Once you’ve logged in properly,

your browser should display the

 “ThissitemightrequirethefollowingActiveXcontrol...”message,as

shown below.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 59 60

Brak uwag

Intellinet-network NSC18-WN User Manual Instrukcja Użytkownika Strona 16